HNC Electric SV-E3 Series, Instruction Manual

Page: 92 / 178

92
Return to the display to change the parameter No.
(Display parameter 2.0)
Press button
Press UP button to change the parameter No.
Display parameter 3.0.
Press button once
Display the setting value of parameter 3.0.
Press button to set the related parameters. We can go to the next step after all the parameters are set.
Press three times
Switch to the mode of setting panel.
Switch to parameter saving mode.
Press button once
Save the parameter to the EEPROM in drive.
(When saving,
『
P
』
in
『
SAVE_P
』
will flicker.)
To the end.
-
Please cut off the power supply to the drive and restart. After restart the power, the setting
will be effective.
Note 1: The control power for models of 750W or less is supplied from external 24VDC.For 1kW or more, is supplied from
internal. Therefore, the control power for models of 1kW or more can be ON/OFF by switching on/off the AC power supply of
main circuit.
8.2 Position control mode (Pulse position command input)
8.2.1 Wiring for user I/O connector (CN1) (Differential input)
Name Symbol Terminal
No.
Signal name Contents
User I/O
●24V power
supply input
●Parallel I/O
●Pulse command
input
●ABZ output
CN1 1 24V Drive control power supply 24V input
2 G24V Drive control power supply GND
3 COM+/- I/O power supply 24V input
4 SVON Servo ON input
5 RESET Alarm reset input
6 HOLD Command input restriction
7 PCLR Deviation counter clear input
8 - Reserved
9 CCWL CCW drive input restriction
10 CWL CW drive input restriction
11 TLSEL1 Torque limit input
12 COM- I/O power supply GND
13 MBRK Brake release output
14 SERVO Servo status output
15 POSIN Position completion output