HNC Electric SV-E3 Series, Instruction Manual

Page: 81 / 178

81
645. 0 [Special setting]
Base signal 1
selection for Home
position
Select Base signal 1 at determine Home position.
0 = Arbitrary position
1 = Stopper
2 = Home position DOG front end
[Initial value] 2 (Home position DOG front end)
[Setting range] 0 to 2
No
645. 1 [Special setting]
Base signal 2
selection for Home
position
Set another base signal(Base signal 2)for home position after detecting Base signal 1.
0 = None
1 = Encoder Phase Z
[Initial value] 0 (None)
[Setting range] 0 to 1
No
645. 3 [Special setting]
Home position
Base signal 1
redetection
Set the Base signal 1 redetection in creep speed after detecting home position DOG
front end.
0 = Disable
1 = Enable
[Initial value] 0 (None)
[Setting range] 0 to 1
No
646. 0 [Special setting]
Home position
return direction
Set Home position return direction.
0 = CCW direction
1 = CW direction
[Initial value] 0 (CCW direction)
[Setting range] 0 to 1
No
646. 1 [Basic setting]
Home position
sensor input
polarity
Set Home position sensor input polarity.
0 = When OFF, detect Home position DOG front end
1 = When ON, detect Home position DOG front end
[Initial value] 0 (When OFF, detect Home position DOG front end)
[Setting range] 0 to 1
No
646. 2 [Basic setting]
Home positon
return Timeout
option
Enable/Disable Home position return Timeout.
0 = Disable
1 = Enable
[Initial value] 1 (Enable)
[Setting range] 0 to 1
No
646.3 [Basic setting]
Point No.0
function selection
Select a function for Point No.0 when PCSTART1 is put into user I/O in forward start.
0 = Return to home position
1 = Point table operation
[Initial value] 0 (Return to home position)
[Setting range] 0 to 1
No
647. 0 [Basic setting]
Home position
return Torque limit
option
Select whether to switch the torque limit value of home position return to home position
return limit value.
0 = Disable
1 = Enable
The torque limit detected by stopper is irrelative to the setting of this parameter in
using home position return of stopper.
No