ENGINE (J05E)/TROUBLESHOOTING
2–443
INSPECTION PROCEDURE: P0336
1.
Check the connection of the engine speed main sensor (crank-
shaft position sensor) connector (looseness and poor contact).
NO
YES
1.
Check the installation of the engine speed main sensor (crankshaft
position sensor).
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the engine speed main sensor (crankshaft position sensor).
NO
YES
1
Inspect the engine speed main sensor (crankshaft position sensor) connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect the engine speed main sensor (crankshaft position sensor)
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the engine speed main
sensor (crankshaft position sensor).
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
