ENGINE (J05E)/TROUBLESHOOTING
2–722
INSPECTION PROCEDURE: P081A
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the starter cut relay.
3.
Set the starter key to the "ON" position.
4.
Select [Engine] and check if P081A has been detected.
NO
YES
1.
Check the connection of the starter cut relay connector (looseness
and poor contact).
NO
YES
1
Check the DTC detected (Engine ECU)
SHTS021270300659
Has DTC P081A been detected?
Go to step 2.
Replace the starter cut relay.
Perform "After-inspection work" of INFOR-
MATION section.
2
Inspect the starter cut relay connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.
