ENGINE (J05E)/TROUBLESHOOTING
2–211
1.
Check the installation of the air flow sensor.
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the air flow sensor.
NO
YES
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU vehicle side
harness. (Do not connect the harness to the ECU.)
3.
Disconnect the air flow sensor connector.
4.
Use the electrical tester to measure the resistance between the
terminals of the engine ECU and ground.
NO
YES
3
Inspect the air flow sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the air flow sensor.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 4.
4
Inspect for short-circuit of the air flow sensor harness
C
D
E12
E78
E74
SHTS021270300192
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Engine ECU (sig-
nal check har-
ness)
VG (E74)
–
Ground
EVG (E78)
–
Ground
VAF (E12)
–
Ground
Do the measurements meet the standard value?
Go to step 5.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.