ENGINE (J05E)/TROUBLESHOOTING
2–559
1.
Check the installation of the intake air temperature sensor (intake
manifold).
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the intake air temperature sensor (intake manifold).
NO
YES
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the intake air temperature sensor (intake manifold)
connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the intake air temperature sensor (intake manifold).
NO
YES
9
Inspect the intake air temperature sensor (intake manifold)
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the intake air tempera-
ture sensor (intake manifold).
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 10.
10
Inspect the intake air temperature sensor (intake manifold) unit
E2
THA
SHTS021270300510
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Intake air tempera-
ture sensor (intake
manifold)
THA
–
E2
20
C {68
F}:
7.336
–
5.794 k
50
C {122
F}:
2.435
–
1.994 k
Do the measurements meet the standard value?
Go to step 11.
Replace the intake air temperature sensor
(intake manifold).
Perform "After-inspection work" of INFOR-
MATION section.
