ENGINE (J05E)/TROUBLESHOOTING
2–738
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the PTO accelerator sensor connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the PTO accelerator sensor.
NO
YES
3
Inspect the PTO accelerator sensor unit
VCC
SIG
GND
SIG
SHTS021270300671
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
PTO accelerator
sensor
SIG
–
VCC
SIG
–
GND
More than 2
Do the measurements meet the standard value?
Go to step 4.
Replace the PTO accelerator sensor.
Perform "After-inspection work" of INFOR-
MATION section.