ENGINE (J05E)/TROUBLESHOOTING
2–184
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the intake air temperature sensor (air flow sensor built-
in) connector.
3.
Use the electrical tester to measure the resistance between the
terminals of the intake air temperature sensor (air flow sensor
built-in).
NO
YES
1.
Check the installation of the intake air temperature sensor (inter-
cooler outlet).
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the intake air temperature sensor (intercooler outlet).
NO
YES
9
Inspect the intake air temperature sensor (air flow sensor built-in) unit
E2
THA
SHTS021270300169
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Intake air tempera-
ture sensor (air
flow sensor built-
in)
THA
–
E2
20
C {68
F}:
2.69
–
2.21 k
60
C {140
F}:
0.667
–
0.493 k
Do the measurements meet the standard value?
Go to step 10.
Replace the intake air temperature sensor
(air flow sensor built-in).
Perform "After-inspection work" of INFOR-
MATION section.
10
Inspect the intake air temperature sensor (intercooler outlet)
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the intake air tempera-
ture sensor (intercooler outlet)
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 11.