ENGINE (J05E)/TROUBLESHOOTING
2–680
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the accelerator sensor 1 connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the accelerator sensor 1 vehicle side connector.
NO
YES
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the DPR differential pressure sensor connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the DPR
differential pressure sensor terminals.
NO
YES
2
Inspect the power supply of accelerator sensor 1
E1
VCP1
SHTS021270300622
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
Accelerator sen-
sor 1 vehicle side
connector
VCP1
–
E1
4.5
–
5.5 V
Do the measurements meet the standard value?
Go to step 3.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
3
Inspect the power supply of DPR differential pressure sensor
VC
E2
SHTS021270300623
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
DPR differential
pressure sensor
VC
–
E2
4.5
–
5.5 V
Do the measurements meet the standard value?
Go to step 4.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.