ENGINE (J05E)/TROUBLESHOOTING
2–223
INSPECTION PROCEDURE: P0108
1.
Check the connection of the boost pressure sensor connector
(looseness and poor contact).
NO
YES
1.
Check the installation of the boost pressure sensor.
2.
Make sure there is no dirt, damage or clogging in the sensing unit
of the boost pressure sensor.
NO
YES
1
Inspect the boost pressure sensor connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect the boost pressure sensor
Was any failure found?
Clean the sensing unit and install it properly.
If damaged, replace the boost pressure sen-
sor.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 3.