ENGINE (J05E)/TROUBLESHOOTING
2–458
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the engine speed sub sensor (camshaft position sensor)
vehicle side connector.
NO
YES
5
Inspect the engine speed sub sensor (camshaft position sensor) power supply
VG
G-
SHTS021270300422
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Engine speed sub
sensor (camshaft
position sensor)
vehicle side con-
nector
G-
–
VG
4.5
–
5.5 V
Do the measurements meet the standard value?
Go to step 6.
Replace the engine ECU.
Perform "After-inspection work" of INFOR-
MATION section.
