ENGINE (J05E)/TROUBLESHOOTING
2–445
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU engine
speed main sensor (crankshaft position sensor to the ECU)
3.
Use the electrical tester to measure the resistance between the
terminals of the engine ECU and engine speed main sensor
(crankshaft position sensor) vehicle side connector.
NO
YES
4
Inspect disconnection of the engine speed main sensor (crankshaft position sensor) harness
D
NE-
NE+
E52
E72
SHTS021270300410
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
Engine ECU (sig-
nal check har-
ness)
–
engine
speed main sen-
sor (crankshaft
position sensor)
vehicle side con-
nector
NE+ (E52)
–
NE+
NE- (E72)
–
NE-
Less than 2
Do the measurements meet the standard value?
Go to step 5.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.