ENGINE (J05E)/TROUBLESHOOTING
2–728
INSPECTION PROCEDURE: P081B
1.
Check the connection of the starter block relay connector (loose-
ness and poor contact).
NO
YES
1.
Set the starter key to the "LOCK" position.
2.
Connect the signal check harness to the engine ECU.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the resistance between the
terminals of the engine ECU (signal check harness).
NO
YES
1
Inspect the starter block relay connector
Was any failure found?
Connect securely, repair if needed.
Perform "After-inspection work" of INFOR-
MATION section.
Go to step 2.
2
Inspect for disconnection in wire harness of starter block relay
A
B
V2
V80
SHTS021270300665
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
Engine ECU (sig-
nal check har-
ness)
STCR (V2)
–
PGD4
(V80)
3 V or less
Do the measurements meet the standard value?
Go to step 3.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.
