ENGINE (J05E)/TROUBLESHOOTING
2–89
1.
Disconnect the J/C_CAN2 connector.
2.
Use the electrical tester to measure the resistance between the
terminals in the CAN H-line and L-line on the J/C_CAN5 side,
viewed from J/C_CAN2.
NO
YES
1.
Disconnect the J/C_CAN1 (22P) connector.
2.
Use the electrical tester to measure the resistance between the
terminals in the CAN H-line and L-line on the J/C_CAN2 side,
viewed from J/C_CAN1 (22P).
NO
YES
2
Check harness in CAN bus line between J/C_CAN2 and J/C_CAN5 (Failure Site 7)
SHTS021270300074
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
J/C_CAN2:
6th
–
17th
110
–
130
Do the measurements meet the standard value?
Connect the J/C_CAN2 connector, and go to
step 3.
CAN bus line disconnection between J/
C_CAN2 and J/C_CAN5
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)
3
Check harness in CAN bus line between J/C_CAN1 (22P) and J/C_CAN2 (Failure Sites 2 & 6)
SHTS021270300075
Measurement
conditions
Tester
connections
Standard values
Starter key: LOCK
J/C_CAN1 (22P):
6th
–
17th
110
–
130
Do the measurements meet the standard value?
Connect the J/C_CAN1 (22P) connector, and
go to step 4.
CAN bus line disconnection between J/
C_CAN1 (22P) and J/C_CAN2
Repair or replace the harness.
Perform After-inspection work. (Clear all past
DTC. Check no DTC is stored after test
drive.)