ENGINE (J05E)/TROUBLESHOOTING
2–145
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the VNT controller connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the VNT controller vehicle side connector.
NO
YES
3
Check the VNT controller power supply circuit
GND
+B
SHTS021270300136
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
VNT controller
vehicle side con-
nector
+B
–
GND
8 V or more
Do the measurements meet the standard value?
Procedure completed.
Perform "After-inspection work" of INFOR-
MATION section.
Check the VNT controller power supply cir-
cuit.
Perform "After-inspection work" of INFOR-
MATION section.