ENGINE (J05E)/TROUBLESHOOTING
2–661
1.
Set the starter key to the "LOCK" position.
2.
Disconnect the accelerator sensor 2 connector.
3.
Set the starter key to the "ON" position.
4.
Use the electrical tester to measure the voltage between the termi-
nals of the accelerator sensor 2 connector.
NO
YES
2
Check the power supply of accelerator sensor 2
E2
VCP2
SHTS021270300603
Measurement
conditions
Tester
connections
Standard values
Starter key: ON
Accelerator sen-
sor 2 vehicle side
connector
VCP2
–
E2
4.5
–
5.5 V
Do the measurements meet the standard value?
Go to step 3.
Repair or replace the harness.
Perform "After-inspection work" of INFOR-
MATION section.