ENGINE (J05E)/TROUBLESHOOTING
2–16
b.
While pushing the primary latch of the connector, move the
lever in the direction of the arrow as shown in the figure
until a "click" is heard and then detach the connector.
c.
Pull out the connector straight.
NOTICE
• Do not insert and remove the connector more than necessary.
• Do not give shocks to the engine ECU.
• Never detach the harness by holding and pulling or prying as it
may result in wire or terminal deformation.
• Never insert a test lead from the rear of the connector.
• Do not paint or apply grease or oil to the connector to maintain
its function and durability.
HINT
If it cannot be pulled out with a light force, check if the lever is
fully open.
(8)
If the side of the harness side connector is found dirty, wipe it
off with a moistened waste cloth while being careful not
allowing dirt and foreign matter to drop.
NOTICE
• Use a thoroughly wrung waste cloth.
• Do not wipe off the terminal opening.
• Do not directly spray water.
(9)
If the engine ECU side connector is found dirty, wipe off its
side with a moistened waste cloth.
NOTICE
• Use a thoroughly wrung waste cloth.
• Do not wipe off the terminal opening.
• Do not directly spray water.
(10) Blow air on the terminal part inside the engine ECU side con-
nector to remove dirt and foreign matter.
Lever
Primary latch
SHTS021270300012
SHTS021270300013
Wipe off
Harness side
connector
Do not
wipe
SHTS021270300014
Wipe off
Engine ECU side
connector
Do not
wipe
SHTS021270300015
