Hill-Rom Advanta P1600, Service Manual

Page: 92 / 429

2.8 Head Section Does Not Go Up
Chapter 2: Troubleshooting Procedures
Page 2 - 26 Advanta™ Bed Service Manual (man168ra)
2.8 Head Section Does Not Go Up
The head section does not go up when the footboard head up switch is
activated.
SHOCK HAZARD:
Unplug the bed from its power source. Failure to do so could result in
personal injury or equipment damage.
1. Unplug the bed from its power source. Manually crank the head section
until it starts to go up from the main frame. Remove the IV rod, plug the
bed into its power source, and activate the head up switch. The head
section goes up.
Yes No
↓ →
Go to step 3.
2. Go to “Final Actions” on page 2-17.
3. Check the head up limit switch adjustment (refer to procedure 4.23).
This solves the problem.
Yes No
↓ →
Go to step 5.
4. Go to “Final Actions” on page 2-17.
5. Set your VOM to check V AC. At J/P7, place the black probe into pin 10
and the red probe into pin 6 (see figure 3-19 on page 3-11). Activate the
footboard head up switch. The voltage is approximately 120V AC.
Yes No
↓ →
If the AC voltage is more than 175V AC, the head drive does not
work (refer to procedure 4.21).
If the AC voltage is approximately 0V AC, then the head motor
does not work (refer to procedure 4.17).
If the voltage is approximately 120V AC, the head capacitor
does not work (see figure 2-6 on page 2-19).
6. This solves the problem.
Yes No
↓ →
Call Hill-Rom Technical Support at (800) 445-3720.
7. Go to “Final Actions” on page 2-17.