Hill-Rom Advanta P1600, Service Manual

Page: 220 / 429

4.12 Air Sleep Surface—Compressor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 36 Advanta™ Bed Service Manual (man168ra)
7. Using the T25 Torx®
1
head screwdriver, remove the screw (B) securing the
air system weld assembly to the frame of the bed.
8. Carefully lift up the air system weld assembly (C) and place it on the thigh
section of the sleep surface.
9. Using the small wire cutters, cut the cable tie holding the large air hose to
the compressor (C).
CAUTION:
Use caution when removing the air hoses from the air sleep surface
solenoid. The fittings are plastic and can break if handled too roughly
during the removal process.
NOTE:
For easier removal, push the air hoses from behind and off of the fittings. The
hoses will not come off if you try to pull them.
10. Disconnect both the large (E) and small (F) air hoses from the compressor
(C).
11. Using the phillips head screwdriver, remove the four screws from the
bottom of the compressor (C).
12. Separate the compressor (C) from the air system weld assembly (G).
Replacement
1. Install the compressor (C) in the reverse order of removal.
CAUTION:
Attach the large air hose to the air sleep surface compressor with a
cable tie. If the hose becomes unattached during operation, equipment
damage could occur.
2. To ensure proper operation of the Advanta™ Bed, perform the “Function
Checks” on page 2-6.
1. Torx® is a registered trademark of Textron, Inc.