Hill-Rom Advanta P1600, Service Manual

Page: 127 / 429

2.23 Scale Display—Err0, Err1, Err2 or Err3 Displayed
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 61
2
2.23 Scale Display—Err0, Err1, Err2 or Err3 Displayed
CAUTION:
To prevent component damage, ensure that your hands are clean, and
handle the P.C. boards by their edges only.
CAUTION:
When working with electronics, wear an appropriate static strap.
Equipment damage can occur.
NOTE:
If the bed is in the correct weigh position, the scale will display 0.0 followed
by the correct weight reading.
1. When the bed is first turned on, the scale displays four dashes (----), beeps
five times, and no buttons function properly.
Yes No
↓ →
Go to step 4.
2. The EPROM is not functioning properly. Replace or repair the EPROM.
This solves the problem
Yes No
↓ →
Go to step 4.
3. Go to “Final Actions” on page 2-17.
4. An Err0, Err1, Err2 or Err3 appears on the scale display.
Yes No
↓ →
Bed is turned off (see On/Off button). If this solves the problem,
go to “Final Actions” on page 2-17. Otherwise, call Hill-Rom
Technical Support at (800) 445-3720.
5. Go to “Err0” on page 2-61, “Err1” on page 2-62, “Err2” on page 2-62, or
“Err3” on page 2-62 as appropriate. If this solves the problem, go to “Final
Actions” on page 2-17. Otherwise, call Hill-Rom Technical Support at
(800) 445-3720.
Err0
1. The scale alternately displays Err0 and ---- . Connect the analog board
cable or replace it.