Hill-Rom Advanta P1600, Service Manual

Page: 277 / 429

4.30 Hilow Foot Limit Switch
Chapter 4: Removal, Replacement, and Adjustment Procedures
Advanta™ Bed Service Manual (man168ra) Page 4 - 93
4
14. Using the T25 Torx®
1
head screwdriver, remove the screw (K) and detach
the limit switch (L) from the hilow strap (R).
15. Remove the two screws (M) from the limit switch assembly (N).
16. Remove the two clips (O) and pins (P) from the torque cage (Q).
17. Using a screwdriver if necessary, remove the hilow straps (R) from the
torque cage (Q).
18. Lift up the radial bracket (S) and hilow straps (R), and slide out the limit
switch assembly (N).
Replacement
1. Lift up the radial bracket (S) and hilow straps (R), and install the limit
switch assembly (N) (see figure 4-42 on page 4-92).
CAUTION:
Do not over-tighten the limit switch mounting screws. Over-tightening
the mounting screws can cause the limit switches to operate
improperly.
2. Using the T25 Torx® head screwdriver, install the screws (M) in the limit
switch assembly (N), but do not tighten.
3. Adjust the hilow foot limit switch assembly so that the tabs (N) are
centered in the slots (see figure 4-43 on page 4-94).
1. Torx® is a registered trademark of Textron, Inc.