Hill-Rom Advanta P1600, Service Manual

Page: 72 / 429

Function Checks
Chapter 2: Troubleshooting Procedures
Page 2 - 6 Advanta™ Bed Service Manual (man168ra)
Function Checks
Mechanical Subsystem Troubleshooting
1. Initial Actions have been performed.
Yes No
↓ →
Perform “Initial Actions” on page 2-5.
2. Operate the bed’s electrical controls individualy while observing the
associated mechanical parts for evidence of damaged components. The
mechanical parts are operating correctly.
Yes No
↓ →
Remove, replace, and adjust (if necessary) the damaged
component(s).
3. Operate the bed’s electrical controls while listening for evidence of
damage to the mechanical components. The mechanical parts are operating
correctly without unusual noise.
Yes No
↓ →
Remove, replace, and adjust (if necessary) the damaged
component(s).
4. Go to “Final Actions” on page 2-17.
Electrical Subsystem Troubleshooting
Use the following isolation sequence for identifying the malfunctioning
component in the electrical subsystem:
1. Initial Actions have been performed.
Yes No
↓ →
Perform “Initial Actions” on page 2-5.
2. The bed is plugged into an appropriate power source.
Yes No
↓ →
Plug the bed into an appropriate power source.
3. Activate the siderail controls and determine if the problem resides in one or
both siderails. The malfunction occurs when either siderail is activated.
Yes No
↓ →
Check for a defective function switch on the switch P.C. board
assembly, and/or a damaged connection between the switch P.C.