Hill-Rom Advanta P1600, Service Manual

Page: 223 / 429

4.13 Footboard Control Panel—P.C. Boards and Cables
Chapter 4: Removal, Replacement, and Adjustment Procedures
Advanta™ Bed Service Manual (man168ra) Page 4 - 39
4
a. Using the phillips head screwdriver, remove the two screws (G) that
secure the connector plate (H) to the footboard (C).
b. Remove the appropriate black connector (I) from the connector plate
(H) by unsnapping it.
c. Remove the appropriate cable (D) from the footboard (C).
Replacement
NOTE:
The connector plate has the cable color names molded into the plastic. When
assembling the black connector to the connector plate, use the cable colors to
correctly position the connectors. One corner of the black connector is cut at a
45° angle to facilitate correct assembly.
1. If you are replacing a cable, proceed as follows:
a. Install the appropriate cable(s) (D) in the footboard (C).
b. Route the cable (D) up through the bottom of the connector plate (H),
and snap the black connector (I) into place on the connector plate (H)
c. Using the phillips head screwdriver, secure the connector plate (H) to
the footboard with the two screws (G).
2. If you are replacing a P.C. board assembly (E), proceed as follows:
a. Place the P.C. board assembly (E) on the correct spot on the footboard
control panel (B), and secure it with the screws (F).
b. Connect the cables (D) to the P.C. board assembly (E).
3. Lower the footboard control panel (B) into the footboard (C) carefully,
being sure not to damage any of the cables (D).
4. Secure the footboard control panel (B) to the footboard (C) with the two
screws (A).
NOTE:
If plastic plugs were covering the screws, replace and secure them.
5. To ensure proper operation of the Advanta™ Bed, perform the “Function
Checks” on page 2-6.