Hill-Rom Advanta P1600, Service Manual

Page: 131 / 429

2.25 Patient Position Monitor (PPM) System Beeps Twice and Flashes LEDs
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 65
2
2.25 Patient Position Monitor (PPM) System Beeps Twice and
Flashes LEDs
The Patient Position Monitor (PPM) system beeps twice, flashes LEDs on the PPM
control panel, and shuts off after trying to arm.
If the Position LED is flashing, proceed to step 1. If the Exiting LED is flashing,
proceed to step 12. If the Out-Of-Bed LED is flashing, proceed to step 26.
NOTE:
It is possible for all three LEDs to be flashing at the same time.
If all three LEDs are flashing at one time, proceed to step 1. Continue as needed.
If there is an error code on the scale display, the PPM system will not arm.
Position LED
1. The Position LED is flashing. See “Zeroing for the Out of bed Mode (Beds With-
out Scales) for beds without scales on page 1-34, or see “Zeroing the Scale” for
beds with scales on page 1-35.
This solves the problem.
Yes No
↓ →
Go to step 3.
2. Go go to “Final Actions” on page 2-16.
3. Ensure the patient is positioned properly on the bed.
This solves the problem.
Yes No
↓ →
Go to step 5.
4. Go to “Final Actions” on page 2-16.
5. Ensure the mattress is one of the following: Comfortline®, ZoneAire® Sleep Sur-
face System, ACUCAIR®, Eclipse®, Maxifloat®
1
, or V-CUE™.
This solves the problem.
Yes No
↓ →
Go to step 7.
1. Maxifloat® is a registered trademark of B.G. Industries, Inc.