Hill-Rom Advanta P1600, Service Manual

Page: 129 / 429

2.23 Scale Display—Err0, Err1, Err2 or Err3 Displayed
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 63
2
connection displayed on the analog P.C. board (see figure 5-3 on page
5-12).
NOTE:
The load beams connect to P1 through P4 on the analog P.C. board.
This solves the problem.
Yes No
↓ →
Make sure that the load beam gap is not closed. If this solves the
problem, go to “Final Actions” on page 2-17. Otherwise, go to
step 3.
2. Go to “Final Actions” on page 2-17.
3. The load beam may be disconnected, not plugged in correctly, or defective.
Connect or replace the load beam (refer to procedure 4.38).
This solves the problem.
Yes No
↓ →
Call Hill-Rom Technical Support at (800) 445-3720.
4. Go to “Final Actions” on page 2-17.