Hill-Rom Advanta P1600, Service Manual

Page: 85 / 429

2.1 Head Hilow Does Not Lower
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 19
2
2.1 Head Hilow Does Not Lower
The head section of the hilow does not lower when the footboard bed down
switch is activated.
1. Set your VOM to measure V AC. At J/P7, place the black probe into pin 10
and the red probe into pin 1 (see figure 3-19 on page 3-11). Activate the
footboard bed down switch. The voltage is approximately 120V AC.
Yes No
↓ →
If the AC voltage is more than 175V AC, the hilow head drive
does not work (refer to procedure 4.22).
If the AC voltage is approximately 0V AC, then the hilow head
motor does not work (refer to procedure 4.18).
If the voltage is approximately 120V AC, the hilow head
capacitor does not work (see figure 2-6 on page 2-19).
Figure 2-6. Hilow Head, Hilow Foot, and Head Capacitor Location
This solves the problem.
Yes No
↓ →
Call Hill-Rom Technical Support at (800) 445-3720.
2. Go to “Final Actions” on page 2-17.
m168_171