Hill-Rom Advanta P1600, Service Manual

Page: 57 / 429

General Operation
Chapter 1: Introduction
Advanta™ Bed Service Manual (man168ra) Page 1 - 39
1
To change from one unit of measure to the other, press and release the
LBS/KGS switch on the scale control panel.
Manual Weight Adjustment
The displayed weight of the scale can be adjusted manually by using the Plus +
and Minus - switches on the scale control panel.
To adjust the weight up:
• Press and hold the Plus + switch on the scale control panel.
• Release the switch when the desired weight is displayed.
To adjust the weight down:
• Press and hold the Minus - switch on the scale control panel.
• Release the switch when the desired weight is displayed.
Indicators
Indicator Lights
Indicator lights are used to inform caregivers of important information
concerning the Advanta™ Bed. Most indicator lights are located on the
footboard control panel.
Motor Power Off: The Motor Power Off indicator light illuminates when the
All Motors lockout switch has been activated.
Ground Loss: The Ground Loss indicator light flashes when the electrical path
to ground has unusually high resistance or when polarity is reversed for phase
and neutral.
Brake Not Set: The Brake Not Set indicator light flashes when the brakes are
not fully engaged. Unless the bed is being moved intentionally, the brakes
should always be applied to help minimize potential safety hazards. This
indicator light is located on the caregiver side of the left head end siderail.
Bed Not Down: The Bed Not Down indicator light illuminates when the bed is
not at its lowest position. For enhanced patient safety, it is recommended that
the bed be in the lowest position unless a caregiver is present. This indicator
light is located on the caregiver side of the left head end siderail.
Service Required: The Service Required indicator light flashes when the
system detects a malfunction.