Hill-Rom Advanta P1600, Service Manual

Page: 248 / 429

4.23 Head Limit Switch
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 64 Advanta™ Bed Service Manual (man168ra)
6. Lift the two CPR latches (G) and the CPR clip (H) to allow the head torque
cage (I) to slide toward the head end of the bed (see figure 4-26 on page
4-64).
Figure 4-26. CPR Latches and Clip
WARNING:
Use a 2 x 4 to support the head end of the bed during this procedure.
Failure to do so could cause the head end of the bed to fall, resulting in
personal injury or equipment damage.
7. Raise the head section, and prop it up in the high position with a 2 x 4.
8. If necessary, remove the screws (L).
9. Lift the CPR latch housing assembly (J) and head drive screw assembly
(K).
10. Slide out the head limit switch housing (B).
m168_063