Hill-Rom Advanta P1600, Service Manual

Page: 69 / 429

Getting Started
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 3
2
Getting Started
WARNING:
Only facility-authorized personnel should troubleshoot the Advanta™
Bed. Troubleshooting by unauthorized personnel could result in
personal injury or equipment damage.
Begin each procedure in this chapter with step 1. Follow the sequence outlined
(each step assumes the previous step has been completed). In each step, the
normal operation of the product can be confirmed by answering Yes or No to
the statement. Your response will lead to another step in the procedure, a repair
analysis procedure (RAP), or a component replacement. If more than one
component is listed, replace them in the given order.
To begin gathering information about the problem, start with Initial Actions.
To isolate or identify a problem and to verify the repair after completing each
corrective action (replacing or adjusting a part, seating a connector, etc.),
perform the Function Checks.
To verify the repair, perform the Final Actions after the Function Checks
If troubleshooting procedures do not isolate the problem, call Hill-Rom
Technical Support at (800) 445-3720 for assistance.
These troubleshooting techniques will help you locate operational problems on
the Advanta™ Bed. This section includes a list of functions and the technical
information required to inspect and diagnose problems. Wiring diagrams for
all of the boards in the Advanta™ Bed are located in chapter 3.
Test Equipment
WARNING:
Only facility-authorized personnel should troubleshoot the Advanta™
Bed. Troubleshooting by unauthorized personnel could result in
personal injury or equipment damage.
You need a digital or analog volt ohm meter (VOM) with fine tip probes to
troubleshoot the Advanta™ Bed.