Hill-Rom Advanta P1600, Service Manual

Page: 303 / 429

4.39 Patient Position Monitor (PPM) Sensor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Advanta™ Bed Service Manual (man168ra) Page 4 - 119
4
3. Using two cable ties, secure the PPM sensor cable (E) to the seat
crosstubes.
CAUTION:
Ensure there are no sharp edges on the drive rivets. Equipment
damage can occur.
4. Check the drive rivets for sharp edges.
NOTE:
To ease installation and prevent cracking, soaking the drive rivets in water is
recommended.
5. Using the four drive rivets (C) with the blue side of the PPM sensor (D) up,
secure the PPM sensors (D) to the bed (see figure 4-54 on page 4-117).
6. Tap lightly with a hammer to properly seat the drive rivets.
7. Install the foot end cover onto the bed (refer to procedure 4.2).
8. Install the footboard onto the bed.
9. Install the mattress on the bed.
10. Plug the bed into an appropriate power source.
11. On beds with ZoneAire® Sleep Surface, press and release the surface
power switch on the footboard control panel. The green indicator light on
the surface power switch will illuminate.
12. Lower the head and knee sections of the bed.
13. See “Zeroing for the Out of bed Mode (Beds Without Scales) for beds
without scales on page 1-34, or see “Zeroing the Scale” for beds with
scales on page 1-35.
14. To ensure proper operation of the Advanta™ Bed, perform the “Function
Checks” on page 2-6.