Hill-Rom Advanta P1600, Service Manual

Page: 236 / 429

4.19 Hilow Foot Motor
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 52 Advanta™ Bed Service Manual (man168ra)
5. Using the T25 Torx®
1
head screwdriver, remove the screw (B) from the
hilow foot motor.
6. Be sure to retrieve the clipnut (F), which could come off the motor bracket
(G).
7. Carefully support the hilow foot motor (C) with your hands and slide the
motor towards the head end of the bed until the shaft disengages from the
drive screw coupling (D).
8. Angle the hilow foot motor (C), and lower it out of the bed.
Replacement
1. You may need to secure the clipnut (F) to the motor bracket (G) with tape
before installing the hilow foot motor (C).
2. Install the hilow foot motor (C) in the bed at an angle, so that the motor
shaft engages the drive screw coupling (D), and the holes in the motor
bracket (G), clipnut (F), and bed frame are aligned.
3. Slide the hilow foot motor (C) towards the foot end of the bed until the
motor shaft fully engages the drive screw coupling (D).
4. Install the screw (B) through the aligned holes in the bed frame, motor
bracket (G), and clipnut (F), and tighten securely.
5. Connect the hilow foot motor power cable (A).
6. Install the motor cover (see “Motor Cover Assembly” on page 4-40).
7. Plug the bed into an appropriate power source.
8. Test the hilow functions of the bed, and ensure it is working properly.
9. To ensure proper operation of the Advanta™ Bed, perform the “Function
Checks” on page 2-6.
1. Torx® is a registered trademark of Textron, Inc.