Hill-Rom Advanta P1600, Service Manual

Page: 260 / 429

4.26 Knee Limit Switch
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 76 Advanta™ Bed Service Manual (man168ra)
4.26 Knee Limit Switch
Tools required: T25 Torx®
1
head screwdriver
Small wire cutters
Removal
1. Raise the head section to 55°.
2. Remove the head motor (see “Head Motor” on page 4-47).
3. Remove the hilow head motor (see “Hilow Head Motor” on page 4-49).
4. Using the T25 Torx® head screwdriver, remove the screw from beneath
the radial bracket (A) (see figure 4-32 on page 4-76).
Figure 4-32. Knee Limit Switch
5. Disconnect the cable (B) at the connector (C) on the logic board.
6. Note the routing of the cable (B) for the knee limit switch housing (D).
1. Torx® is a registered trademark of Textron, Inc.
m168_060