Hill-Rom Advanta P1600, Service Manual

Page: 137 / 429

2.26 SideCom® Communication System Tester
Chapter 2: Troubleshooting Procedures
Advanta™ Bed Service Manual (man168ra) Page 2 - 71
2
Repeat this step for the right siderail.
3. Operate either the inside or outside Nurse Call from the left siderail. The
Nurse Call light on the tester comes on when either switch is activated.
NOTE:
Pressing the Nurse Call switch from the siderail causes the call to be placed
and then released, and is controlled by the bed system. The light will go on and
off.
Yes No
↓ →
The fault is in the corresponding siderail, the cable to the
siderail, or the junction box.
Repeat this step for the right siderail.
4. Operate the Nurse Answer button on the tester. The yellow LED on the
inside of both siderails is turned on.
Yes No
↓ →
The fault is in the corresponding siderail, the cable to the
siderail, or the junction box.
5. Operate the Nurse Call button on the tester. The amber LED on the inside
of both siderails is turned on.
Yes No
↓ →
The fault is in the corresponding siderail, the cable to the
siderail, or the junction box.
NOTE:
The amber call LED on the siderail will be on at half brightness all of the time.
The tester will only make the LED brighter.
6. Operate the Speaker switch on the tester. There is a continuous tone that is
adjusted by the volume controls on the siderail.
Yes No
↓ →
The fault is in the corresponding siderail, the cable to the
siderail, or the junction box.
7. Go to “Final Actions” on page 2-16.