A.10 Notes and Restrictions
417
Configuring Computer’s Settings
• Take care to configure IP address settings correctly. IP addresses are maintained within an
entire system. Be sure to consult your network administrator before configuring IP address
settings.
• Consult your NIS (Network Information Service) administrator whenever configuring network
settings (e.g., IP address) on a computer that is used under NIS (Network Information Service).
Switching the Power Off
Note the following points whenever switching the printer’s power off.
• When the [LPD Spool] setting is [Memory]
All of the print data spooled in the printer’s hard disk, including data that is currently being
printed, is deleted. The print data does not exist is not available when the power is switched
back to on. However, print data may be saved on your computer if the power is switched off
immediately after requesting a print job. In this case, printing will be performed from the
saved print data when the power is switched back on again, even if a new print job has been
is requested.
• When the [LPD Spool] setting is [Hard Disk]
All of the print data spooled in the printer’s hard disk, including data that is currently being
printed, is saved on the printer's hard disk. Printing will be performed from the saved print data
when the power is switched back to on again, even if a new print job has been is requested.
• When the [LPD Spool] setting is [No Spooling]
All of the print data spooled in the printer’s receiving receive buffer, including data that is
currently being printed, is deleted. The print data does not exist is not available when the
power is switched back to on. However, print data may be saved on your computer if the power
is switched off immediately after requesting a print job. In this case, printing will be performed
from the saved print data when the power is switched back on again, even if a new print job
has been is requested.
Printing
• When the [LPD Spool] setting is [Hard Disk] or [Memory]
If the size of the print data is greater than the remaining capacity of hard disk or memory
capacity at the time that receiving the print data receive starts, that print data cannot be
received.
Note
• Some computers may resend the print data immediately automatically if the size of the print data exceeds the
receive capacity. If this happens, it may appear as if the computer has hung up. To avoid this, cancel sending
print data on the computer.
• When the [LPD Spool] setting is [No Spooling]
While a print request is being received from one computer, a print request from another
computer cannot be received.
• When the computer’s IP address or and computer name has been changed
The query contact processing or canceling requests from the computer and the delete process
may not operate correctly after the computer’s IP address and/or the computer name has
been changed. While there is no print data in the printer's receive buffer, turn the power off
and then back on again.
Note
• A control panel operation can be used to cancel or force-eject printing of the print data in the printer's receive
buffer. For information about the procedure you should use, refer to "2.5 Canceling/Checking a Print Job"
(P. 52).
