Fuji Xerox DOCUCENTRE-II C3000, User Manual

Page: 539 / 603

ESC/P Emulation
537
Ap
pe
nd
ix
17
Reduce/enlarge 54
(Reduce/
enlarge mode)
Sets the print magnification.
[0] (Default)
: Preset %
[1] : Variable %
[2] : Fit to Cut Sheet
[Preset %] is a magnification calculated automatically based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
original to fit to the printable area of the output paper. Therefore, if the
size of the original and that of the output paper are the same, the
magnification will be 100%. Also, if [2 Up] is selected, the original will be
reduced to the size where two pages fit into one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all texts,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area to the printable area of
the output paper. It is a magnification calculated automatically based on
[Original Size] and [Paper Size], and reduces/enlarges the whole original
(including the area outside of the printable area) to fit to the printable
area of the output paper.
17
(Variable %/
vertical
magnification)
Sets the magnification for the vertical or horizontal direction.
[45 to 210] (Default:100):45-210%
Note • When a continuous form paper is selected for [Original Size], both
[Preset %] and [Fit to Cut Sheet] produce the same print result.
18
(Variable %/
horizontal
magnification)
2 Up mode 21 Sets whether to print in 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default)
: Off
[1] : Reverse
[2] : Forward
Important • When [Landscape] is selected for [Original Size], [Forward] or
[Reverse] produce the same print result.
Output
destination 9 Sets the output tray where the output will be delivered.
[0] (Default)
: Center Tray
[1] : Side Tray (optional)
[2] : Center Output Tray-Lower
[80] : Finisher Tray (optional)
Tray 5
confirmation 67 Prints from Tray 5 (Bypass), after instructing to print and then operating
the machine to start printing.
[0] (Default)
: Off
[1] : On
Grid lines 22 Sets the method for printing 2-byte grid lines. The options are as follows.
[0] (Default)
: Image
[1] : Font
Setting Item
Item
Number
Value