Fuji Xerox DOCUCENTRE-II C3000, User Manual

Page: 270 / 603

11 System Settings
268
Sy
st
em Set
tin
gs
11
Auto Print
Set the time period to start the next print job after finishing a copy operation.
When [On] is selected, specify a value between 1 and 240 seconds, in 1 second increments.
If you select [Off], printing starts immediately after the machine is ready.
Printer Lockout Duration
The machine disables to print fax documents received and reports during a given period of
time.
If you selected [On], specify a starting time and an ending time to disable printing, in one
minute increments.
Note • A job which has already been activated before the starting time will be printed continuously
even after the starting time elapses.
• The print-disabled condition is canceled when you operate using the control panel after the
ending time.
• To enable printing during the printer lockout duration, select a job under [Current and
Pending Jobs] on the [Job Status] screen, and then select [Promote Job].
Auto Power Saver
The machine is provided with the Low Power and Sleep modes as the power saving mode.
When a specified period of time has elapsed, the machine switches to these modes in the
following order to reduce power consumption.
Last selection on the machine
J
Low Power mode
J
Sleep mode
For more information, refer to "Changing the Power Saver Mode Change Interval" (P.33).
Note • There is no setting to disable switching to the Low Power mode or the Sleep mode.
„ From Last Selection to Low Power Mode
Specify a time period between the last operation and entering the Low Power mode in the
range from 1 to 240 minutes, in 1 minute increments.
Note • Configure the [From Last Selection to Sleep Mode] time to be longer than the [From Last
Selection to Low Power Mode] time.
„ From Last Selection to Sleep Mode
Specify a time period between the last selection and entering the Sleep mode from 1 to 240
minutes, in 1 minute increments.
Audio Tones
Select whether or not to sound an alarm, for example when a job ends or a fault occurs.
Control Panel Select Tone
Select the sound to be made when a button displayed on the screen is correctly selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Control Panel Alert Tone
Select the sound to be made when a button that cannot be selected is selected, or an error
occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].