Fuji Electric Faldic-a Series, User Manual

Page: 134 / 251

MHT258a (Engl.) 5-51
■
Interface
■
Parameter setting
To allocate the fixed/passing point 1 signal to the control output terminal, set (17) to the system para. Set (18) for the fixed/passing point 2.
■
Related items
・ Selection of output form
Output form can be set by basic para. 62 to 65.
Basic parameter 62 to 65
Para. Name Setting range Initial value Change
62 Fixed/passing point detection 0 : Fixed point
1 : Passing point off
à
on
2 : Passing point on
à
off
0 Always
63 Fixed/passing point detection position 1 0 to
±
79,999,999 (in increments of 1)
[x unit q’ty]
0 Always
64 Fixed/passing point detection position 2 0 to
±
79,999,999 (in increments of 1)
[x unit q’ty]
0 Always
65 Fixed point detection range (zone) 0 to
±
79,999,999 (in increments of 1)
[x unit q’ty]
100 Always
・ Valid or invalid of position detection function
Position detection function such as fixed/passing point 1 can be effective after origin return end.
Basic parameter 67
Para. Name Setting range Initial value Change
67 Position detection function valid/invalid 0 : Valid after origin return 1 : Always 0 Always
5.7.6 Override
This function changes the current motor speed.
While “ override effective ” (43) signal is turned on, the motor speed is variable by a scale factor specified by “ override 1/2/4/8 ” up to 1.5
times the current speed.
Weighting of scale factor corresponding to override 1/2/4/8 can be changed by basic para.
This function is effective for any rotation command except for torque control, pulse train input (pulse train ratio 1 or 2).
This function will not be effective after the ON edge of interrupt input in interrupt positioning.
■
Interface
Fixed/passing point 1 (17)
Fixed/passing point 2 (18)
ON/OFF : Automatically turns on or off according to the current position
Override effective (43)
Override 1 (44)
Override 2 (45)
Override 4 (46)
Override 8 (47)
+24V
P24
M24
2.2k
+24V