show inline-power
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
535
NOTE
For additional information on inline power parameters, refer to the
show power budget
command.
To reduce the chances of ports fluctuating between powered and non-powered states on modular
switches, newly inserted PDs are not powered when the actual delivered power for the module is
within approximately 19 W of the configured inline power budget for that slot. However, actual
aggregate power can be delivered up to the configured inline power budget for the slot (for example,
when delivered power from ports increases or when the configured inline power budget for the slot is
reduced).
Example
The following command displays inline power status for the system:
show inline-power
Following is sample output from this command on a modular switch:
Inline Power System Information
Configured : Enabled
System Power Surplus : 1500 Watts available for budgeting
Redundant Power Surplus : 465 Watts available for budgeting to maintain N+1
Power Usage Threshold : 70 percent (per slot)
Disconnect Precedence : lowest-priority
Legacy Mode : Disabled
Budgeted Measured
Slot Inline-Power Firmware Status Power (Watts) Power (Watts)
3 Enabled Operational 50 W 9 W
4 Enabled Card Not Present ( 50 W) n/a
7 Enabled Operational 50 W 0 W
Note: A budget value in parentheses is not allocated from the system power
budget because the card is not present, or the slot is disabled.
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on the G48P and G48Pe modules installed in the BlackDiamond 8800 series
switch and the Summit X450e-24p switch.
