VLAN Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
780
(P) EAPS protected vlan, (r) RIP Enabled, (T) Member of STP Domain,
(v) VRRP Enabled, (B) 802.1ah Backbone VMAN, (S) 802.1ah Service VMAN
Total number of svlan(s) : 1
NOTE
The show
svlan <svlan_name>
display may differ slightly depending on the platform and configuration you are
using.
The following is sample output for the
show svlan <svlan_name>
command when you are displaying
a service VLAN (SVLAN) for a MAC-in-MAC tunnel:
BlackDiamond 12804.36 # show svlan servtest
SVLAN Interface with name servtest created by user
Admin State: Enabled Tagging: 802.1Q Tag 200
Priority: 802.1P Priority 0
Virtual router: VR-Default
IPv6: None
STPD: None
Protocol: Match all unfiltered protocols
Loopback: Disable
NetLogin: Disabled
QosProfile: QP1
Dot1ah Mode: Service
I-SID: 250
In Backbone: backbone
Ports: 0. (Number of active ports=0)
NOTE
If you did not configure an ISID, the I-SID line does not display. (The system uses the value of the S-tag if you do
not optionally configure an ISID.)
The display from the
show svlan detail
command shows all the information shown in the
show
svlan <svlan_name>
command, but displays information for all configured SVLANs.
Displaying EtherTypes.
The following is an example of the display from the
show vman etherType
command when you configure MAC-in-MAC tunnels (802.1ah):
BlackDiamond 12804.41 # show vman etherType
vman EtherType : 0x88a8
bvlan EtherType: 0x88b5
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available only on the BlackDiamond 10808 and 12804 switches.
