OSPFv3 Commands
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
1610
configure ospfv3 add interface all
configure ospfv3 {domain <domainName>} add [vlan | tunnel] all {instance-id
<instanceId>} area <area-identifier> {passive}
Description
Enables OSPFv3 on all VLANs or all tunnels (router interfaces).
Syntax Description
Default
OSPFv3 is disabled on the interfaces.
The default instance ID is 0.
Usage Guidelines
This command is used to enable the OSPFv3 protocol on all IPv6 configured VLANs or all IPv6 tunnels.
The instance ID is used to control the selection of other routers as neighbors. The router will become a
neighbor only with routers that have the same instance ID.
An interface can have only one instance ID associated with it in one OSPFv3 domain. However, the
same interface can be associated with another OSPFv3 domain with a different instance ID. An interface
associated with two OSPFv3 domains cannot have same instance ID.
To change the instance ID associated with an interface, you must first remove the interface from the
OSPFv3 area and then add it back with a different instance ID.
The passive parameter indicates that the router only synchronizes and listens, and does not originate or
send any new information on the interface.
Example
The following command enables OSPFv3 on all IPv6 tunnels:
configure ospfv3 add tunnel all area 0.0.0.1
domainName
Specifies an OSPFv3 domain. OSPF-Default is the only one currently
supported.
all
Specifies all IPv6 configured VLANs or all IPv6 tunnels.
instanceId
Specifies the instance ID for these interfaces. Range is 0 to 255.
area-identifier
Specifies the area to which the interfaces are assigned.
passive
Specifies to stop sending and receiving hello packets on this interface.
