show vlan
ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ExtremeWare XOS 11.5 Command Reference Guide
783
The following is an example of the
show vlan Default
command:
VLAN Interface with name Default created by user
Admin State:
Enabled
Tagging: 802.1Q Tag 1
Priority: 802.1P Priority 0
Virtual router: VR-Default
Primary IP:
10.0.0.1/8
Secondary IPs:
12.0.0.5/8
IPv6: None
STPD: s0(Disabled,Auto-bind)
Protocol: Match all unfiltered protocols
Loopback: Disable
NetLogIn: Enabled
QosProfile: QP1
Ports: 771. (Number of active ports=0)
Untag: 3:2, 4:1, 4:2, 5:1, 5:2, 5:3, 5:4,
5:5, 5:6, 5:7, 5:8, 5:9, 5:10, 5:11,
5:12, 5:13, 5:14, 5:15, 5:16, 5:17, 5:18,
5:19, 5:20, 5:21, 5:22, 5:23, 5:24, 5:25,
5:26, 5:27, 5:28, 5:29, 5:30, 5:31, 5:32,
5:33, 5:34, 5:35, 5:36, 5:37, 5:38, 5:39,
5:40, 5:41, 5:42, 5:43, 5:44, 5:45, 5:46,
5:47, 5:48, 5:49, 5:50, 5:51, 5:52, 5:53,
5:54, 5:55, 5:56, 5:57, 5:58, 5:59, 5:60,
5:61, 5:62, 5:63, 5:64, 5:65, 5:66, 5:67,
5:68, 5:69, 5:70, 5:71, 5:72, 5:73, 5:74,
5:75, 5:76, 5:77, 5:78, 5:79, 5:80, 5:81,
5:82, 5:83, 5:84, 5:85, 5:86, 5:87, 5:88,
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (a) Authenticated NetLogin port
(u) Unauthenticated NetLogin port, (m) Mac-Based port
NOTE
The
m
flag for MAC-based port represents network login information; it is only supported on the BlackDiamond 8800
series switch and the Summit X450 family of switches.
NOTE
The
number of active ports
line displays the number of ports presently in forwarding state on this VLAN.
The output for the
show vlan detail
command displays the same information for all VLANs
configured on the switch.
NOTE
See
Chapter 23, “IP Unicast Commands,”
for information on adding secondary IP addresses to VLANs.
History
This command was first available in ExtremeWare XOS 10.1.
The IPv6 information was added in ExtremeWare XOS 11.2.
