Eaton RF System 2.42, Manual

Page: 75 / 244

75 Eaton RF-System
© 2015 Eaton Electrical Group
whether it is to be sent according to a cycle time (to be adjusted with a slider control).
Room controller with humidity (CRCA-00/03):
In addition to the functions described above, the room controller with humidity has a second
channel for measuring the relative air humidity (0-100%).
As in the case of temperature measurements, there are two modes, Send switching command and
Send humidity value, and the option to set an offset value or switching hysteresis value.
The same setting options as for temperature measurements apply to humidity measurements, but
the position of the adjustment wheel has no effect on the humidity channel.
As shown on the device icon, when connecting the temperature channel to another device, the line
is drawn from the left side of the icon, whereas it is drawn from the right for humidity values.
See also Configuration Example for Room Controller
Temperature Input
The temperature input serves as a sensor and can control all xComfort actuators (switching
actuator, dimming actuator, shutter actuator) and it can send a measured value (temperature) to
the Home Manager.
In order to scan it, just take off the cover and when prompted (You can now activate
battery-supplied devices …) press the activating key.
It provides two inputs (channel A, channel B) for external temperature sensors, which cover a
measuring range from -50°C to +180°C.
In case the temperature set is either not reached or exceeded, it can either send a switching
command to the Home Manager, or the temperature measured
–
just like the room controller.
Both input channels (A und B) are independent from each other and can be treated separately.
Sending a switching command: