Eaton RF System 2.42, Manual

Page: 9 / 244

9 Eaton RF-System
© 2015 Eaton Electrical Group
Fixes a rare issue that will prevent the USB-RF-configuration stick from losing its
RF-parameters and making it inoperative
Group connections that could not be calculated completely will no longer display a mixture
of red and black connections but only red (uncalculated) connections
Scanning an actuator will now correctly scan the manual routing flag in order to display the
different connection type correctly
Transfer virtual device functiuon and replace device will now correctly transfer all
Room-Manager shading settings
Saving the messages of the RF-monitor will again save the message data
RM-Software update: It is no longer possible to downgrade a Room-Manager with a
version greater than V39b to a lower version. Please always only use the actual Room-Manager
Version (V40a) that can be found in the MRF directory in the subfolder "Device
software\Room-Manager"
Virtual Room controllers used for Heating actuators will now be inserted with the right
mode (Send temperature value)
How to start
After starting the program, the MRF main window will be displayed.
Before starting the program, however, you should connect the Gateway (RS232 interface). If you
wish to do this later, you can do it in the menu item Establish Connection (See
Go Online )
Under Options you will see how to select the interface you want to connect the Gateway to.
As soon as the connection to the Gateway is established, you can start to scan all the desired
devices.
After scanning all the mains-supplied devices placed within the reception range, you will be
prompted to activate any battery-supplied devices. In case there are no such devices, activate the
Quit button.
Note: Always scan mains-supplied devices before you activate any battery-supplied devices. To
make it easier, a scanning window displays which and how many of the devices have already been
scanned.
Then your main window should more or less look like that: