Eaton RF System 2.42, Manual

Page: 128 / 244

128 Eaton RF-System - Help
© 2015 Eaton Electrical Group
If the setting is 1 impulse the motion detector reacts immediately on movement. If the setting is 7
impulses, 7 movements has to be detected before it reacts.
Setting of the operation mode for both channels:
The mode configuration is used in the basic mode to assign the motion detector to actuators. The
channel of the Motion detector always is equal to the state of its DIP-switch.
When you push the activation key now the following command is sent (if only channel A is ON):
„Motion detector (Channel A) sends <ON> to everyone“
Same goes for channel B. So that
’ s how you can assign the motion detector to actuators or
activate it for scanning in the comfort mode.
When you do a long key press of the activation key the channel that
’ s DIP-switch is ON sends an
OFF command. So that ’ s how you can unassign a connection in the basic mode.
In the mode operation the channels are activated for operation and the state of each channel is
only determined by movement detection. Every single channel or both channels can be activated
or deactivated.
Setting for the Detection-LED:
With the 1.11 DIP-switch you can determine if the detection-LED lights every time movement is
detected.
In the comfort mode the motion detector is handled like a binary input in mode 2. So the
assignment to other devices is very similar.