Eaton RF System 2.42, Manual

Page: 42 / 244

42 Eaton RF-System - Help
© 2015 Eaton Electrical Group
connections established.
A connection that was established using manual routing will always be displayed as a black dotted
line
Only one connection with either automatic routing or manual routing may run out from a sensor
channel, never a mixed connection.
You can have MRF recalculate at any time a connection that was set up with manual routing. In
this manner, it loses its manually-entered path and the MRF attempts to calculate the routing
under consideration of the reception quality.
If you need to draw out the manual routing from a multi-channel sensor, you must select the
respective channel after pressing ENTER. The possibility that you have to select the sensor
channel multiple times (for each of the resulting connections) is possible if multiple connections
are set up as a result of the drawn-out routings.
Replace device
Using this function you can replace an existing device in the project by a new one. (f.E. if a device
is defect). You have to scan the new device first. It has to be the same type of device like the old
one.
Then you can start this function and follow the instructions on screen.
IMPORTANT!!! After clicking OK you should immediately click on the “Load” button or menu ->
actions -> load.
New for V2.41:
The design of the function has been changed and it is now possible to replace more device in one
step (similar to
Transfer virtual device functions )
There are options to also use the device name and reception quality for the replacement device.
As before these options are per default activated.