Eaton RF System 2.42, Manual

Page: 13 / 244

13 Eaton RF-System
© 2015 Eaton Electrical Group
The Commands 1, 2, 3, 4 (File Menu)
Use the numbers and file names listed at the end of the File menu to open the four projects you
closed last. Select the number of the project you wish to open.
The Command Quit (File Menu)
Use this command to close your session. The xComfort MRF Software asks if you wish to save
projects with modifications not yet saved.
Shortcuts
Mouse: Double-click the system menu of the application.
Keyboard: ALT+F4
Commands of the Edit Menu
The Edit menu includes the following commands:
Undo Undoes the previous action
Redo Repeats the last undone action
Connection mode Activate or deactivate draw mode
This allows the connection (configuration) of two devices
Selection mode Activate or close selection mode
It is possible to select more than one device.
Define password ... You can define the system password.
Load password Loads the defined password in the devices.
Delete password ... Deletes the password in the devices and resets the system
password.
Options ... Opens the window with the setting options
Undo
When this function is executed, the last action that was triggered through an MRF command is
undone.
A maximum of 5 steps can be reversed, whereby only those commands that actively change
something in the configuration can be undone.
This function is reset by executing the functions Load, Scan, or Scan Reception Quality.
Redo
This function becomes active when the Undo function has been previously executed at least once.
It restores the previously reversed action. This function is reset by executing the functions Load,
Scan, or Scan Reception Quality.
Connection Mode On/Off
With the drawing mode on/off you can select if Connections should be drawn or if the device icons
on the screen should be dragged and dropped.
The position of the device icon is saved in each device, so in case of rescanning xComfort
products there is no need to position them again in the desired place.