Eaton RF System 2.42, Manual

Page: 158 / 244

158 Eaton RF-System - Help
© 2015 Eaton Electrical Group
Assigned device: The name of the connected intelligent device will be displayed here
You should activate the function „send own temperature to intelligent device“ if you want to use the
Radiator thermostat as a Room temperature sensor in the connected intelligent device. If you have
a connection to a Room-Manager you can choose to set one of the connected radiator thermostats
as Room temperature sensor in the settings window for the Room. If the room temperature is
already measured by another sensor (Room controller or temperature input) this function should
not be activated.
Request/Regulation
time: You can set the time that the device will communicate with the intelligent
device in order to get a new Set- and actual temperature. If new data has
been received the valve position will be recalculated based on these
values.
Offset of the measured
temperature: You can set an offset temperature for the internal temperature sensor of
the device. That is necessary because eventually the temperature
measured near the radiator can be different than the temperature in other
areas of the room. So you can make sure that the thermostat will regulate
to the right temperature in the room and not just the temperature near the
radiator.
Frost protection: You can set the temperature that is used for frost protection (7°C per
default).
The frost protection is active if the actual temperature falls below this