Chevrolet 1977 10 Series, Repair Manual, Page: 367 / 468

AUTOMATIC TRANSMISSIONS (400)7A-47
Fig. 7 A-1 5 3 C - M o d ific a tio n o f S e rvice Case fo r C o rve tte
M o d e ls
ASSEMBLY OF UNITS TO TR A N SM ISSIO N
CASE
NOTE:
The first three steps can be om itted if the parts
involved were not removed on disassembly.
1. Install parking pawl tooth tow ard inside of case, and
parking pawl shaft (Fig. 7A-154C).
2. Install parking pawl shaft retainer clip (Fig. 7A-
155C).
3. Install parking pawl shaft cup plug and drive into the
case, using a 3/8 dia. rod, until the parking pawl shaft
bottom s on the case rib (Fig. 7A-154C).
4. Install parking pawl return spring, square end hooked
on pawl and other end on case.
5. Install parking bracket with guides over parking pawl
using two attaching bolts, torque to 18 ft. lbs.
6. Install rear band assembly so that two lugs index with
two anchor pins. Check to make sure band is seated on lugs
(Fig. 7A-156C).
Fig. 7 A-1 5 5 C --ln s ta llin g P a rk in g S h a ft R e ta in in g S p rin g
RETAINING
SPRING
SHAFT
REAR
BAND
Fig. 7 A-1 5 6 C —In s ta llin g Rear Band
f
M
CENTER SUPPORT !
i f ■ t o CASE SPACER]
L
o c a t e s p a c e r g a p
I
a d j a c e n t t o
1 BAND ANCHOR PIN
Fig. 7A-1 54C—Installing Parking Pawl Shaft Cup Plug
Fig. 7A-1 57 C —Installing Center Support to Case Spacer