Chevrolet 1977 10 Series, Repair Manual, Page: 366 / 468

(400)7A-46
OVERHAUL MANUAL
Fig. 7 A-1 4 9 C ~ ln s ta llin g R o lle r in to R o lle r C lu tc h Cage
Fig. 7 A - 1 5 1C—In s ta llin g C e n te r S u p p o rt to R e a ctio n C a rrie r
17. Install rollers th at may nave come out of the roller
clutch cage, by compressing the energizing spring with
forefinger and inserting roller from the outer edge (Fig. 7A-
149C).
18. Install roller clutch assembly (Fig. 7A-150C) into
reaction carrier.
19. Install center support to reaction carrier thrust
washer into recess in center support. Retain with petrolatum
(Fig. 7A-47C).
20. Install center support into roller clutch in reaction
carrier (Fig. 7A-151C).
NOTE:
W ith reaction carrier held, center support
should only turn counter-clockwise after installation.
21. Install J-21795 on gear unit assembly to hold units
in place.
22. Install output shaft to case thrust washer tabs in
pockets (Fig. 7A-152C), and retain with petrolatum .
NOTE:
This must be a metal washer.
CASE M O D IFIC A TIO N -C O R VETTE
NOTE:
D ue to the configuration of the body floor pan,
it is necessary to modify the standard Service Case when
used as a replacement part for the Corvette.
Using a "C" Clamp, clamp the transmission case firmly
to a suitable bench, with the converter under pan attaching
face down, as shown in Figure 7A-153C, (do not damage
machined surface of the case).
Using a hacksaw, remove the two front manufacturing
lugs (one on each side), as close to the wall of the case as
possible, using caution not to cut into the wall of the case.
ROLLER CLUTCH
ASSEMBLY
THRUST WASHER
(METAL)
Fig. 7 A -1 5 0 C -ln s ta llin g Roller Clutch to Reaction Carrier
Fig. 7A-1 52C—Installing Case to Output Shaft Thrust Washer