Chevrolet 1977 10 Series, Repair Manual, Page: 316 / 468

(350)7A-32 OVERHAUL MANUAL
Stator Shaft Rear Bushing
W ith stator shaft properly supported, remove front
bushing (fig. 7A-102B). Place tool J -2 1424-7 and drive handle
J-8092 with extension J -2 1465-13 through front of stator
shaft and drive out two (2) rear bushings. Using tool J-23062-
2 and extension J -2 1465-13, install inner bushing to
approximately 1-5/32" below front face and outer bushing
3/32" below front face (fig. 7A-102B). Install new front
bushing (fig. 7A-101B).
input Ring Gear Bushing
W ith input ring gear properly supported, remove
bushing using tool J-23062-5 and drive handle J-8092. Using
tool J-23062-5 and drive handle J-8092, install bushing to
approximately 1/16" below rear face inside gear end (fig.
7A-103B).
Sun Gear Bushing
W ith sun gear properly supported, remove two (2) sun
gear bushing using tool J-23062-3 and drive handle J-8092
with extension J-2 1465-13. Using tool J-23062-3 and drive
handle J-8092, install sun gear bushing to .010" below surface
at either end (fig. 7A-104B).
Reaction Carrier Bushing
W ith reaction carrier properly supported, remove
bushing using tool J-23062-3 and drive handle J-8092. Using
tool J-23062-3 and drive handle J-8092, install bushing flush
to or .010" below inside face.
Direct Clutch Bushing
W ith direct clutch drum properly supported, remove
bushing (fig. 7A-105B). Using tool J-23329 and drive handle
J-8092, install direct clutch drum bushing (fig. 7A-106B).
Fig. 7 A - 1 0 4 B ~ l n s t a l l i n g Sun Gear B u s h in g s
TR A N SM IS S IO N ASSEMBLY
When servicing transmission, use only transmission oil
or petroleum jelly as lubricants to retain bearings or races
during assembly. Lubricate all bearings, seal rings and clutch
plates prior to assembly.
Transmission Internal Components
1. Install low and reverse clutch piston assembly with
notch in piston installed adjacent to parking pawl.
2. Install seventeen (17) piston return (coil) springs.
3. Install spring retainer and retaining ring. Using tool
J-23062-3
S U N G E A R
A S S E M B L Y
S U N
G E A R
D R I V E
S H E L L
J-8092
J - 8 0 9 2
J -2 3 0 6 2 -5
INPUT
R IN G G EA R
CAPE CHISEL
BUSHING
DIRECT CLUTCH DRUM
Fig. 7A - 10 3 B —Installing Input Ring Gear Support Bushing
Fig. 7A-105B~Removing Direct Clutch Drum Bushing